Hi all I installed the filters that fit between the d sub cables and the skyview and now is all good
still dont know why it was good for 8 years and only started getting interference now
Hi when I flew today RV12 rotax powered I was getting the squelch opening on the radio I tried adjusting it out but couldn't It transmits and receives ok
I tried turning off each magneto, GPS , strobe etc but no difference but when I shut down the skyview the squelch cleared It also does...
Hi I am in Australia and I get a no high res terrain warning all the time
can I disable it
also why does the glide ring show about a 5 mile radius when on the ground
ashley
I Also had 3 crosses appearing but only for a few seconds it was caused by a wire to the gps aerial rubbing on the choke cable and sometimes shorting to earth
Thank you I pulled the cowlings off and checked the wires leading to the GPS aerial and found that one of them had been rubbing on the throttle cable which had been causing an intermittent short all fixed now
I am using the sv gps 250 one display
Its in an RV12 with a rotax The skyview installation is not the standard Vans install I installed it before Vans offered it I have flown over 300 hours with no problems It was just a random fault with the map going out first with a red cross and then it...
Today when I went for a quick fly the map screen went black with a red cross for a few seconds the map went back to normal and then when I was coming in to land the all 3 screens went blank with red crosses for a few seconds it came back ok for a few seconds then went blank again for a few...
The user waypoints that I loaded via the dynon usr program dissapeared when I loaded 3.1 and the jepperson data base and I cant seem to reload them what am I doing wrong
I imported and downloaded the EMS-912-01072010 file to the skyview but it still only gives me the option of lycoming continetal or other engine what have I done wrong
ashley