Recent content by FSGOM

  1. F

    WIFI serial data

    Quite good improvement of sending serial data via WIFI. Thanks Dynon Question, Request: Would it be possible to transmit in the stream also the tuned/standby radio frequency?
  2. F

    Time difference on displays

    both have battery backup , right display was booted later manual.... because sometimes with the master switch only the left screen starts.
  3. F

    Time difference on displays

    Two displays SV1000 , latest SW After booting the right one doesnt start up , after manual booting , I detected a time difference during the whole flight of about 32 seconds, right was later than the left one. The GPS fix UTC info on both were different as well. What could cause this?
  4. F

    No database sync between 2 screens

    Hi Dynon we have 2 D1000 (S/N 4xxx) linked with ethernet but the DB synchronisation doest not work. Everything else is fine. Any suggestions? Thx
  5. F

    Flight log

    Hi Dynon I want to suggest an new feature for pilot flight logging and info. We are running 2 WT9 in a community. We want to import a pilots flight book directly into our accounting software. I think this feature would be helpfull for many pilots or charters. Procedure suggest: - Each pilots...
  6. F

    V15.3.3 Sensor Settings

    During update to this version, Skyview lost some customized sensor settings. After reload the archive seetings it works again: Example of lost user sensor: Fuel preasure for Rotax engines: c37_p8={ valid=1 name=FUEL id=Alex Road P906.B001.0S...
  7. F

    Weight & balance

    Is it possible to change it to kg ,cm and Liter?
  8. F

    Probable fix for AP disconnects, cautions, red-x

    SkyView 14.0.7.3621 : No problems anymore (ground check only) Thanks Dynon
  9. F

    V14 - Error PFD & AP

    Re: V14 - Error PFD & AP - 14.0.7.3621 SkyView 14.0.7.3621 : No problems anymore (ground check only) Thanks Dynon
  10. F

    Trying to revert to 13.0.3

    Reverted to V13.0.3 - succesfull, no problems
  11. F

    V14 - Error PFD & AP

    Hi Dynon Support since V14 we get on ground and inflight multiple times a red cross on the PFD screen (2 Displays) for some milliseconds. Also the AP disengages (what's wanted). I will send you the diagnostic file. Thanks Michael
  12. F

    Suggestions for after boot infoscreen

    We are using our plane with many different pilots. We want to inform the pilots with latest, special infos ,etc. I think this also can be helpfull for charter planes using Skyview to inform the customers. The next version could be a SHUTDOWN IMAGE beside the 30 seconds counter.
  13. F

    Suggestions for after boot infoscreen

    There were always suggestion for a boot screen or something like that. Maybe skyview can implement a solution like that (see attached mockup). Display a custom picture (JPG or PNG) after booting. To give the pilot a specific info,text with graphics,logo. Should be separate for each display...
  14. F

    Flam to SV settings

    These settings on Powerflarm are working.
  15. F

    Skyview V13.0.3 little bugs

    1st: Graphic's error in the airport INFO DIALOG (gray vertical bar). 2nd:  Setting the NEAREST runway length to 100m  doesn't work anymore. Heliports are shown , which we do not want to.(Graphic error as well in the header) . Whats the meaning of U (undefined ?) 3rd: Graphics on MAP: Sometimes...
Top