Search results

How about a VOR/ILS Nav receiver remote that can be accessed by the SkyView Package. Smilin' Jack

I have a dual dynon setup with a 10 inch display and a 7 inch display, the EMS 220 and 470 ADS-b. The only issue I have is when I key the mic for my MGL V6 is that the tapes for CHT and EGT all increase. And then return back to normal after the transmission is over,  if I am in the lean mode on...

How do I copy the EMS CHT and EGT profiles shown on the Skyview display. I need to send a readout to GAMI to set my injectors and they said if I can get a readout from the Skyview, then they could analysis it. Help. Smilin' Jack

What buttons do I push to download the CHT and EGT values as shown on the Dynon Skyview EMS page. Do I just take a photo of it. I would like to be able to recall the readout for a time period such as 30 minutes. Can you help. Can I view these? Smilin' Jack

Yes but it seemed to work on the first flight but on the second was the first time I called ATC to get a verification of the altitude and they had me climb up to see if they could see me when they could not see me at a lower altitude where they normally see other aircraft in this area. I can see...

I have dual SkyViews and the 261 xponder,  indications are that the transponder is working but ATC can not see me.  They could see no aircraft. At an altitude well above what they. Normally can see.I did my first flight of my RV 7yesterday so I will trouble shoot it and see what I can find,  I...

Thanks for the reply Jack

I just finished installing the ADS-B and the Skyview display states partial under the ADS-b. under the system setup serial port it states no signal but are receiving a few bits. The ADS-B box is blinking rapidly.. I believe tha t all is working well with the aircraft on the ground and will...

I too bought the V6 MGL after being told by Nick at Dynon that the comm would be out in a year. That was At Oshkosh 2011.So in July of 2012 I was told the Dynon com again at Oshkosh,would be out by November.... Well that did not happen.. But the progress on my plane continued and I ended up...

I just applied power to the Skyviews yesterday and it could not find the EMS or the Transponder. I checked the power to the transponder and it was fine and the EMS is just connected to the Hub. On the Transponder, I did serial runs to both skyviews. The wiring of the transponder is just a...

That's what I did yesterday. Just ahead of the F707 bulkhead with the top aft skin off. Thanks Smilin Jack

Where have you folks mounted an ADAHRS unit in a RV 7 Thanks Smilin Jack

I have installed the SV32 in my wing and now the questions concerns the limiting bracket. In the directions there is no picture as to the orientation of the bracket. Anyone have a picture of the restrictor bracket installed on the servo? If not for Dynon, how does the bracket mount. I can...

Tnks I have it mounted Smilin Jack

I have just purchased an SV32 roll servo for the right wing of my RV7, I thought it would be prudent to install this during the assembly of the wing. My initial problem is this: The servo arm is positioned to the left below center of the servo body. The servo arm looks as though it is pinned and...