Search results

When I started my engine today my skyview screen without a backup battery went black while booting up. Then the screen display was verticle lines. I rebooted three times and had the same result, no display only lines. About 5 minutes later the system rebooted on its own and came alive as normal...

My experience is that the FISDO does not get involved. If your setup passes a regular VFR transponder check, you should be good to go. I don't understand his point.

Wow, great support, the new servo came in noon UPS delivery. I had a little trouble getting the arm off the servo to mount the capstain, but after getting it wired and installed did a test flight. The AP calls for trim but less than before and when disconnecting the airplane pitches up and then...

The servo has not been taken apart. I will give support a call.

I'm testing my installation, Murphy Moose with capstain drive servo's. When the AP is disconnected I go a pitch down. The procedure used is trim airplane with AP off and then engage AP for straight and level. The AP slips and calls for trim and I trim until no slip and trim request. When the AP...

Thanks, I'll try that.

I tried to load a flight plan from Flitesoft and Skyview does not do the file transfer. Has anyone loaded a GPX file from Flitesoft? I've loaded plans from AOPA ok, but not Flitesoft.

I had the same problem. I put a cable stop on one end of the bridle cable against the aluminum block. Then pulled tension on the bridle cable while sliding the aluminum block, I had tools in place and tightened the bolts   while pulling the block. It took as couple of tries to get things...

I have installed a Skyview system with pitch and roll servos. So far I have about 8 hours but only a couple of minutes of AP flight. Is there anyone flying with capstan drives on a Moose that can give some insight on their setup? In my initial test there was a great deal hunt and seek and I...