Search results

Will I have any issues downloading the new firmware to my D100 that I have been operating since Feb? And other than a different look, will the existing functions still work the same if I am able to download? The way my D100 is working now has been great!! :o

The internal battery is installed and tested. Works great. ;D I test flew it again (second flight now) and the system works wonderfully. Thanks again for all the help!!

Thanks for the tasks.  I flew 1.3hrs, first flight behind the D100, and it was very nice.  However the internal battery still showed I 00.0.  I will follow your suggested procedures and let you know what happens. Mystery solved!!  No internal battery!!  I will be calling Gulf Coast-Avionics in...

My D100 is newly installed and has about .4hrs of ground run time for testing and calibration. The VMETER shows the current voltage (fine), 0.0 on the enternal battery (E) because there is none, but I purchased the internal backup battery (I) which shows 0.0 as well. I connected the "stay...

Just an additional note for the Garmin user. Once you get the correct plug that includes the output connection that goes to pin #22, you will need to make sure you enter your Garmin set-up. I believe in the system tab, you will have to make sure the 296 to set to provide the output. I have a...

:)Thanks for the help over the phone. After our conversation about things to check, it was the system setup on my GPS. Once that was set the feed came in just fine in the hangar (expect of course, "no fix detected" because of the inability to see the sky. I received the GPS in the magenta...

Thank you. I should be out the hangar tomorrow, but it is snowing AGAIN in the Denver area so I would get to test fly until maybe Saturday.

Is navsrc a select button on the Dynon menu?

Will a Garmin 196 show simulated information on the HSI of the D100 while parked in the hangar testing systems?

I have just got my D100 running and have done some initial set-up. I used the output data line from my Garmin 196 to pin 22 (#3 on the serial port) to display the information to the HSI. To see if it is working I thought I would run the GPS on simulator mode in the hangar to see the data on...

I have not fired up my D100 yet, but sent it in for the screen upgrade and requested the firmware be upgraded at the same time. I was reading the installation manual and there was a reference to both the unit and EDC having the same or both updated firmware information. I wonder if the...

Thanks for the follow up. I think I have it now, and should have the entire panel redone by the first of the year. I will let you know if things are acting up after install and set-up, but from everything I have read on this site there are very few squawks.

Sorry, still a little confused.  I went to the page on the link that explained the wiring needed if you only have a D100, which is my set up.  It said I needed to "hook the GPS transmit line into pin 22. This is the same Serial Rx line that is used for firmware updates. You will need a way to...

I am nearing completion of installation of my D100, and I am not seeing the connection points to include data from my GPS (Garmin 196). I have seen some other comments where people have had issues with their EFIS seeing their Lowrance GPS, but nothing about the Garmin or who to wire this...

Where can I get the information on setting up a manometer? Thanks, Pat