Search results

I have cycled the power with the master switch many times. I only have one display I also have a VPX installed and have cycled the power to the transponder with that.

ScreenShot of display after v14 update.

The update seemed to finish and when rebooting it shows V14. It was on the reboot after the update that the transponder did not come up and the screen looks just like the one above.

Mine is doing the same thing. Doing the power cycle hasn't helped so far. Any other suggestions.

I have the AP installed in a PA11 replica. I have not tried to use it in flight yet but have gone through the complete checkout and calibration. Both of my servos are capstan drive. the roll servo seemed to work as advertised, I could override the servo with ease at 60%. The Pitch servo was...

PA11 Experimental With a full 10" Skyview system, including AP and ADS-B

I have to use 18mm ring sensors on my 0--200. I ordered Falcon CP-018 CHT Senders, but the color code on the wires is white and black. I cannot find out what type of thermocouple wire they use so suspect they won't work. What ring sender do you recommend.

Got it working. Had not done the calibration on the Skyview. Hard to find and not mentioned in the manual that I could find.

Have my trim hooked up to a VPX Sport. Using a Ray Allen pos 12 on the trim. Works great when setting it up on the computer on The VPX Configurator. I set the Skyview setup page under VPX setup to be VPX on the trim. No Red X. So VPX is talking to it. However I do not show a position on the...

Any chance the garmin GDL 39 can be used with Skyview

Thanks for the follow up. Will start bugging Mark.

David, there might be more than 1 or 2 % of us out there that understand engines and their instrumentation. Not rocket science for someone that grew up building engines..

Can the V10 MGL radio be controlled from Skyview. I see it can be controlled by the Enigma or the Odyssey.

Don't understand. I have it running on Skyview and configured. What could I do on the website to change that.

I was told you would have some answer in April. Any luck yet.

Don't think I will find out. Just re plumb

I use a quick coupling under the header tank to fuel my plane. It uses a pump that pumps about 3 to 4 gal per min. I was going to install the red cube directly under the header tank above the quick connect, but have no idea of what reverse flowing fuel through it would do to the cube. Would it...

I have just connected my VPX Sport. When I go to the VP-X page, it displays all the outputs for J8 which is on the Pro only. How do I get them to go away and display only my outputs.

The three crimp on male connectors were not included in the package with the sensor. Is this something I need to try to find or are they normally furnished.

Posted these picts just to show a alternative method of driving the ailerons on a plane with a torque tube.