Search results

I rechecked the configuration of the CNX-80(Garmin-480) and is as follows. Serial port number 1 TX(transmit) is set to MAPCOM at 9600 baud. This configuration works! Thanks again! Larry Smith

Hello Dynon. I have two D10a units in my RV. The upper one is the primary flight display and the lower is the HSI (nav display). I am driving the HSI with an CNX-80 (now Garmin-480) The previous version (3.0) was not compatible with the CNX-80. I am VERY HAPPY to report that V4.0 now drives...

I can now report on the V3.0 version compatability with the CNX-80 (Garmin 480). The CNX-80 is not compatible at this time. Once initialized and the CNX-80 position is fixed, the D10A shows an intermittantly flashing 'Waiting for gps position fix". The CNX-80 is fully up and running. This is...

I am currently using Anywheremap to drive the efis D-10A in HSI mode. With the previous version it drove the efis acceptably. The only issue was with the HSI course being locked at 360. After upgrading to 3.0, I can now sync with the actual course. The issue now is that the gps data drops...

Will this unit support the Garmin 480? What are the expansion module dimensions and can it be mounted horizontally as well as vertically? Thanks. Looking forward to the module addition. L. B. Smith

There is a posting on the AWM website discussing the fact that the Dell pda's do not output a signal for the autopilot and therefore the dynon either. I have a similar setup but use a HP ipaq to output to my Dynon and Autopilot. The only issue is that Anywheremap doesn't provide the necessary...

How about using the a couple of the hard buttons to manually rotate the HSI to the appropriate course? Similar to the way the heading bug is set. This for people with gps's that don't output the proper sentences to rotate it automatically.

Hi, What happend to the new release? It was there earlier and now has apparently been pulled. Thanks