Search results

I have tested my fuselage harness, specifically the 8 wires from the ADAHRS to the control module and there is continuity. How do I test the female side of the connection on the control module? I bypassed that by running a test 9 pin cable directly from the ADAHRS to the extra port on the...

yes they both have shown up, the one that shows the corrupt message seems to need updated, but wasn't able.

several times with both ADAHRS

Thanks, I've spoken with Bill and he is going to help.

Oregon/Washimgton????? might as well be Bora Bora to a Light Sport plane in North Carolina

When it all started they said that there were updated adjustments that needed to be made in the ADAHRS. They did that but sent it to me and it worked in an inverted manner. They then sent me another, but it failed on the first flight after about 30 minutes. At that point I did go to an...

well like I said it was plug and play from Dynon/Van's. I did nothing different than the plans showed.

No, I do not have a back-up ADAHRS. just one primary (200), and one screen Skyview Touch. It was all pretty much plug and play with the Van's RV12 Kit.

Well I hope I get a solution soon, can’t fly it like it is!

Most appreciative of the geography lesson, most helpful. After 400 hours of running perfectly, the attitude screen went nuts, altitude to 52000 ft, airspeed 0, overspeed alarm blaring, etc., etc. I've had several iterations of the above, but nothing that stays fixed. At this point, the...

I have a SkyView Touch in my RV12 that at this point is unusable. I can’t say enough good about the support I have received from Dynon. However they are in Oregon, I’m in North Carolina. Two close shops are installers for Dynon, both have 6-8 months waiting lists to even get into. Does...

Did you find a solution out in Australia?

I am so curious if you have solved this issue! I am having the same issue that Dynon does not seem to have a solution for. A new screen, two new adahrs, and no improvement. RV 12, 400 trouble free hours Skyview touch, ap, Ems, ap panels, back-up battery...the entire set-up as plug and play as...

Skyview Touch: I bought the entire system through Vans with my RV-12 and it included a dimmer switch for the display. It has never worked. The wiring came already assembled, all I did is basically attach the rotating knob to the panel. I never thought that I would fly at night but I now find...

I would like to add this, I have an RV12 with a SkyView touch, with everything installed as per the Van’s standard kit configuration. I was at Oshkosh and saw your installations, and it appeared that it was a simple plug in installation. I have no “extra” places to plug this in anywhere. Am I...

Is it possible to fly using just the heading bug without the altitude hold engaged?

May, 2016, yes through Van's RV 12

bought May 2016 thru Van's, yes RV 12