Search results

With the help of tech support I was able to fix the problems I had with AP74. first problem was gps not set up right. I reset the options in set up menu of Garmin 396. second problem was the white wire going to the blue wire of the ELT was shortted out (Vans says this hookup is not necessary as...

I have a RV-12 with D180 running ver. 5.4.0 My Ap74 is not fully functional. I cannot use track and nav..both will not lite up when pushed. Heading and alt work fine. When I do a DSAB config. I get an error when I push finish and autopilot goes off. don't know if this unit has ever worked. I...

after updating D180 to 5.1.1 did DSAB and got msg no OAT found. did DSAB :(again and watched OAT count down from 175 to what would be normal temp then go to not available. OAT is connected to EFIS and was working in past.

got a new D180 on rma 5876 and installed it and now getting DSAB error msg (lost peers) this unit has version 5.1.1 and I believe my old unit had 5.0 or 5.1. I am not able to make the unit busmaster. My laptop has Vista on it and I cannot comunicate with the D180. have checked the wiring and it...

I am getting an error code 8 when trying to do DSAB config. what does this mean? only setup I am not able to do is the north --south, east -- west as engine is not running yet. all other sensors are configed. where do I find a list of error codes on your site? :(

I am going to calibrate the efis and DSAB today and will let you know the outcome, thanks Dennis

I powered up my ap 74 and all lites stay on. I have all three red wires going to ap bus/switch. yellow disengage is not hooked up yet and pin 25 is not to ground. used DSAB from 25 pin efis going to blue and green. have three blacks going to ground. any hints on what may be wrong? :(

Is the pickup for RPM still off key switch P-leads if using bendix mags? and if so do I need resistors and what rating? :P

thanks for the reply,but my bellcrank is different than yours and I don't have the space to mount right at the bellcrank. I will be using about a 4' push tube from the actual wingtip and tie in to the bellcrank. Dennis

Has anyone mounted the roll servo in the wing tip of an RV6-a and do you have pictures? Are there any issues other than heavy wing with it out there? thanks Dennis ::)