Search results

Hi I have both EFIS , EMS and AP 74 installed in my panel, I just installed AP and connected GPS signal to pin 22 on the EFIS, just read in the installation guide this suppose to be installed to pin 19 on the EMS when both EFIS and EMS is installed. Do I need to rewire to pin 19 on EMS? Regards...

I plan to install autopilot and already have HS34 modul together with Efis D-100. is it possible to use the HS34 with the autopilot?

I have installed EFIS D100, EMS D120 and HS 34 in my plane since 2010 without pany problems. Yesterday just before take of the engine stopped and when i started again there was no information from the EMS. Only the message on the EFIS D100. EMS MAIN EMS NOT DETECTED Any who can help here...

I have problem with reseting my CHT alarm cyl. 2. after been using heat gun to identify the different probes. Cylinder 2.showing X and I'm not able to reset this and get it showing the temp. I have set the sky view up to clear alarms but this dosen`t clear this alarm. Anybody experience the...

I have problem with the EMS shutting down and switch on again frequently. EMS is connected to the Dynon EFIS via DSAB. I have checked all connections for lose cables but all looks ok. Could it be a problem internly the EMS? Thanks Borge :)

I have bought Rotec electronic ignition for my Jabiru 2200 and by connecting the lead (tachometer output) from ignition to my EMS nothing happens, anybody familiar with this problem? Would it be possible to connect the orginal mag. pickup standard Jabiru to the EMS? :) Regards Borge

I have installed an EFIS 100 with the remote compass in my Jabiru 170 but have problems with numbers in the EFIS 100 fluctuate. The remote compass is installed under the left seat with no electric cables close to it. Anybody that have experience the same problem? Thanks Borge :)

I followed the recommendation and connected the EMS tachometers left wire to one of the alternator wire but then my charge light disappeared. then I connected the EMS to left and right magneto through an 30k ohm resistance. Is there any chance for those to connectors to be short circuit in the...

The amp. bar on my EMS is fluctuating, is that normal? if not could it be sorted by installation of an resistor (size) :)

When I power up the EMS there is a click noise every 5 sec. Is that normal? Regards Borge :)

:)I have the left wire from ems connected to the alternator on a Jabiru 2200 engine. The tach. works fine up to 15-1600 rpm but then start jumping up and down from 1600 to 2500 rpm. Would an resistor sort this problem? (if so, what size) Regards Borge

I`m in process of installing a Dynon AMP shunt Specs 0-60A. And I wonder which end of the shunt is AMP high and which is the AMP low one side of the shunt is marked 40A and the other end is marked 40mv. Thanks Borge

When connecting the tachometer sensor wire to the alternator wire how many pulses should be entered in to the EMS set up? Thanks :) Borge

Jabiru 170 owner Where is the best place to intall the senso on a Jabiru 2200 egine? Should it be installed between the engine fuel pump and the carburettor? Regards Borge :)