Search results

How about the reverse condition?  Will the EMS share the OAT from the EFIS? Thanks, Sam Chambers

;D Great!! Thanks, Sam Chambers Long-EZ N775AM

So that feature is not in the release just anounced? Thanks, Sam Chambers Long-EZ N775AM

:) Is this included in the latest upgrade just announced? Thanks, Sam Chambers Long-EZ N775AM

How about compatibility with Garmin 296/396/496 and other hand-held GPS units? Sam Chambers

:'( Thanks, I will use the EI input alone, but wire both the tach and EI for the future upgrade. Sam

:)Dynon,  Do you have the tach set up for different pulses per rev for each input yet? Thanks, Sam Chambers Long-EZ N775AM

:-? I think I know the answer to this already, but I will ask anyway. I would like to shorten the pigtails on the EGT and CHT thermocouples to place the connectors at a better location in my pusher installation.  Is this OK, or do I need to leave them the original length? Sam Chambers...

I am ready to install my ammeter shunt.  I previously had an EI volt/amp gage using an external shunt.  It was mounted on the bottom of the engine case on an existing boss.  Will the shunt Dynon supplies be OK mounted there as well?  All my wiring will fit up if I can mount it there-I will just...

8-) Thanks so much.  I thought I would have to use the 5vdc excitation from the EMS as I could not find any generators that did not use 5v.  I will wire as you say and if I get the rpm too low by half, I will brag about how fast my EZ is  :). Sam Chambers Glasgow, KY Long-EZ N775AM

:question I ordered one of these, but it did not come with any information at all about the output.  What did your employee use for a format and how did he connect the sender? Thanks, Sam Chambers Long-EZ N775AM

8) 8) Great, any idea when? Thanks, Sam Chambers Lng-EZ N775AM Hi, guys, I did not see a response anywhere to this and am just about ready to install my EFIS & EMS.  I have one impulse-coupled mag and one Eledtro-Aire electronic ignition that outputs two square wave pulses per rev.  If it...