Search results

  1. J

    EMS 221 GP Thermocouple input with 912iS Engine

    I am helping a friend wire his plane with a full Dynon avionics system.  His engine is a Rotax 912iS with a CAN BUS to be connected to SV-EMS 221 pins 36 and 37.  Is there a way to connect a general purpose type J thermocouple to the EMS 221?  If so, what pins?
  2. J

    Compatibility of GTX-345 with SkyView

    Will the SkyView display traffic and weather from a Garmin GTX-345 ADS-B-IN-OUT transponder?
  3. J

    SV-D1000 power pins 1 & 20

    Are pins 1 & 20 on the SV-D1000 connected internally?  The reason that I ask is that the RV-12 kit comes pre-wired with pin 20 always hot and pin 1 switched.  See the RV-12 schematic http://tinyurl.com/RV-12-Schematic and my post on VansAirforce questioning the wiring...
  4. J

    Flap Deployed warning above VFE

    VFE is shown on an air speed indicator as the top end of the white arc. I want to install a limit switch on the manual flap mechanism and connect it to a SkyView contact input. If the flaps are deployed when the airspeed is above VFE, I want the SkyView to give an alarm message. Does the...
  5. J

    Autopilot servo shaft wobble

    I read that excessive play in the control linkage causes poor autopilot performance. So I checked the linkage on my RV-12 by putting the roll servo in test mode and moved the flaperon by hand. The control stick moved whenever I moved the flaperon. That means that there is not much play in the...
Top