Search results

  1. T

    Amps Draw Indication

    The shunts resistance is fine and all connections and continuity is fine. When the 2 wires are shorted it still reads the 47 amps...
  2. T

    Amps Draw Indication

    Hi, My HDX system has recently shown a bizzare indication for the amps draw. The shunt is installed in position B. The EMS LED is flashing fast red, the network config says the EMS is status: ready with no faults. The EMS was recently replaced. When only the HDX is powered, the volts show 12.4...
  3. T

    EMS Issue

    Thanks once again. I'll eagerly wait for your tech dept response. Cheers
  4. T

    EMS Issue

    Thanks for the advice Kurt, greatly appreciated! Would any Dynon techs like to respond please? Cheers
  5. T

    EMS Issue

    Hi Guys, I'm hoping you can offer some advise - some info for me to pass onto the workshop. My aircraft is in with the avionics guys having a full skyview HDX package installed. During the first engine run, all things were fine then on shut down the EMS failed - was returned for repair. Upon...
  6. T

    Skyview HDX instal question

    Thanks guys! My tech replied with " I have performed the tests for the ems as per dynon. I also checked continuity of the network cable and its ok. I have confirmed the ground connections pins 2&3on the network cable connected to the display and that 8.09 volts dc pins 7& 9is available to the...
  7. T

    Skyview HDX instal question

    Hi guys, hoping tech spt could please help with a couple of things. We have the hdx , EMS just installed into an RV7A. (Light speed and mag ignition and capacitive fuel sensors.) 1. Rpm is displaying approx double its value on the skyview 2. On the first engine run the EMS was working fine...
  8. T

    HDX Instal - Rc Allen Elevator Trim - Dyon display

    All is good. I think he missed the last sentence in the manual.... thanks Jake and I do hope it works out :-/
  9. T

    HDX Instal - Rc Allen Elevator Trim - Dyon display

    He's using the latest from the web site: Document 101320-027, Revision AB, March, 2017, which refers to page 7-66 "Trim and Flaps Position Potentiometers". Position potentiometers may be connected to any general purpose input pin on the SV-EMS- 220/221’s D37 and must be calibrated according to...
  10. T

    HDX Instal - Rc Allen Elevator Trim - Dyon display

    Hopefully this will be the last question I need to ask on behalf of the workshop installing the HDX into my RV7! Previously I had the Rc Allen electric elevator trim (push buttons on the control column) with the indicator outputs displaying on the traditional Rc Allen LED trim display...
  11. T

    HDX Install question

    Thanks for the advice. The tech is slowly moving along and for the time being we will stay with the tru track Cheers!
  12. T

    HDX Install question

    Thanks Ray, please excuse my terminology. If we only wanted the GNS430 to supply info to the sky view HSI, where the TT autopilot only steers the 430, is this simpler to achieve? I wasn't aware the TT could steer the skyview? Cheers Damian
  13. T

    HDX Install question

    Hi guys, My RV is at the workshop having the following installed: HDX, engine sensors, ARINC, coupled to a Garmin 430. Prior to the instal the Garmin 430 was only linked to my TruTrak digi 2 autopilot. The avionics guy today was scratching his head saying something about gamma signals and not...
Top