Search results

Have 2 friends that each purchased half of a D180, D100 combo. Both of these friends did not purchase the AP/Servos. The original owner of the combo had the AP/Servos. That being said, I cannot figure out how to fully remove the AP from each of these screens. I have reconfigured the DSAB bus...

I know the legacy gear is sort of in maintenance mode but: After flying behind several brands of EFIS systems, it has become very clear that the Dynon D6/D10A/D100/D180 products would benefit from a little more filtering on the ASI. The digital values are a just too nervous. When used with...

Can you please fill me in on the size and thread pitch of mounting studs on the D6/D10A? Mine did not come with any nuts or hardware. oh...almost forgot!  Can you also please tell me what the radii of the corners of the faceplate are on the same units?  I may have to have a spacer machined and...

I read in the manual that the serial stream is configurable for what data you want to stream as well as the baud rate based on the port configuration. At what rate does the Skyview send out the sentences? Thanks, Brantel

Please look into adding support for some of the newer solid state pressue sensors like the ones that Garmin is providing with the 3GX systems. It seems that these are way more accurate than the mechanical ones expecially on low pressure applications such as fuel pressure for carbs. Garmin list...

Dynon, Please walk me through your design intent on how you guys programmed the Legendary system to flow when using a 430W, AP, and HS34 when shooting a LOC based approach. I will list what I have been doing but would like to know if there is a better procedure. Scenario: Using the 430w to...

Any reason why the inbound course needs to be manually selected on the HSI when transitioning from GPS Nav to VLOC on a localized based approach? This is with a 430w and HS34.

Dynon Support, Can you fill us in on how your AOA indicator maps to the 00-99% of stall angle output on the serial port in the streaming data? In other words, where is the top of the Green and bottom of the Yellow begin & where does the top of the Yellow and the bottom of the red begin? Thanks!

DynonSupport, What is the rate at which you send packets out of the serial port on the D100? I know the baud rate is 115K but how often do you send a packet?

I was out last night doing some practice simulated approaches and trying to use the timer built into the D100. Ran into a couple issues and this is repeatable: First thing you might run into is the fact that when you have the timer menu up and active, none of the HS34/AP74 knobs work. The...

I have noise over my intercom when I dim my system and the white lights to come on inside the HS34 and AP74.  The buzzing sound changes with different dimming levels. Has this ever been reported and is there something I can do to reduce this noise being introduced into my intercom? I used a...

Dynon, I can confirm that the Nav source lost bug still exist with 5.3 and the Aera 510... On a two hour flight today it happened about 10 times... Totally random and had no rhyme or reason to it....

I seem to always have HDG and ALT modes armed on power up of the AP74. Is there a way to prevent this so the system powers up with no modes armed? The reason I ask is that I like to have the bugs set to sync on arm and since the modes are armed on power up, I have to disarm them and rearm them...

I was on the first of a two leg flight plan where the second leg was about 175° from the original leg and here is what happend: http://i50.tinypic.com/6hl277.jpg I do not know if this was caused by the AP or the GPS... Any ideas on why this would happen?

Looks like Garmin is using these low range FP sensors: http://www.kavlico.com/_assets/pdf/P4055DS.pdf Any chance we could use one of these with the D180/D120? The current supplied sensor....well...stinks.

Dynon, I have the recommended 30K ohm resistors on my O-360's Slick Mag P leads at the switch. On climbout, I sometimes get erratic RPM readings and occasional High RPM warnings that are false. In cruise, it reads normally most of the time. Should I increase or decrease the resistor value to...

Proud to report that N159SB took to the sky on 3/20/10.... All electrons powered by Dynon Avionics!!! First takeoff: 1st Landing: The RV Grin!!!: All electrons powered by Dynon Avionics!!!

Dynon, D120 question.... What sort of step change should we see when using your converters with a standard rv7 tank with properly installed capacitive senders by Van's? What is the resolution of the converters? When calibrating mine I get several steps that read the same...With the warning...

Is it safe to run the AP cables out to the wing and back to the back and not connect a servo to it? I have pre-wired my plane but will not start out with the servos installed. Will the DSAB bus not like having those long cables with nothing connected to them on the end? I am worried about...

Does the internal backup battery have a fuse inside it or a current limiter circuit? I ask because the edges of the metal around the area of the connector are sharp and could cut the insulation of the battery and connector wires over time. I do not want a 16V Lion battery melting down in my...