Added a Heated Pitot & Connection to EMS

rfazio1951

Member
Joined
Feb 11, 2010
Messages
354
I added a heated pitot to my RV-6. I also ran the indicator wire to my EMS pin 10 as contact. I went in and added the sensor as a contact and put the contact indicator on the engine page. I can't seem to get it to work. I went in to the EMS setup page and I can see the contact is working. When I put the pitot on I see 5 volts on that pin and when I shut it off it goes to zero. But no indication on my contact indicator on the 100% page? What am I doing wrong?
 

Raymo

I love aviation!
Joined
Apr 25, 2016
Messages
1,043
Location
Richmond Hill, GA
Richard,

I suggest running through the setup again that begins on page 15-1 of the install manual, rev AD (though the the revision at the bottom of each pages says AC).
 

rfazio1951

Member
Joined
Feb 11, 2010
Messages
354
Ray,

     Thanks for the response. I did use the install manual for the setup. So I went out to the airport and went in and checked it again, line by line. I had it wrong. It now works, thanks.
 
Top