I have two D10As hooked together via DSAB and an SL-30 hooked to one of the D10As for HSI and Glideslope.
The second D10A causes the CDI and Glideslope to flicker horribly when connected via the DSAB bus. This is the CDI and lideslope displayed directly on the primary EFIS page.
Both D10As are running 4.0.0.
With the other D10A off the primary CDI and Glideslope works without flicker but I need the second D10A as it provides the magnetometer.
I have also tried changing the BAUD rate on the SL-30s serial interface but it made no difference.
Any solutions?
Thanks,
Cory
The second D10A causes the CDI and Glideslope to flicker horribly when connected via the DSAB bus. This is the CDI and lideslope displayed directly on the primary EFIS page.
Both D10As are running 4.0.0.
With the other D10A off the primary CDI and Glideslope works without flicker but I need the second D10A as it provides the magnetometer.
I have also tried changing the BAUD rate on the SL-30s serial interface but it made no difference.
Any solutions?
Thanks,
Cory