EFIS D10A to EMS-D10 Display

[aceflyingservice]

Does the EMS-D10 currently have the capability to display the EFIS D10A screen via the blue & green wire bus connection? I hooked mine up but couldn't get it to work. I configured the EMS global option for switch 6 but when pushed the screen goes blank. Thanks for the help.

Roger

 

[dynonsupport]

The EMS-D10 can currently display an EFIS-D10A via the serial connections that are normally used for PC updates. If you put a null modem between these connections (pins 2&3 swapped) then the EMS can display the EFIS.

The DSAB bus is not currenly supported, but will be in a software update in a few months. For now, you must use the serial ports.

The information how to make the EMS - EFIS connection is on page 23 of the EMS installation guide (rev B).