Elevator Potentiometer

[brochinejr]

Hello,
I am trying to use skyview but I am having some problems.
I have 2 SkyView 7” Display, I was having this problem before and I still having the problem after that I update 2.6 firmware.
I have a rotax 912, first pin number 23 to elevator potentiometer, it do not work. After that I tried to use pin 12 , but It do not work to. It is strange, looks like the comportment is not linear.
I am having problem with manifold sensor too.
Can you help me anyway?

 

[dynonsupport]

First, make sure that the under SETUP>EMS SENSOR SETUP>SENSOR INPUT MAPPING is set to the right function. Next, did you calibrate the trim?

What's going on with the MAP sensor?

You might want to give us a call from the aircraft so we can help you understand some of the settings.