EMS-D10 and 150psi sensor for fuel pressure

[tpatja]

I recently converted my engine to use electronic fuel injection and switched my fuel pressure sensor from the Dynon 15 PSI sensor to the Dynon 150 PSI sensor (sold as "oil pressure sensor", but same kind of Kavlico sensor as 5, 15 and 50 PSI).

Is there a way to configure the sensor to show correct values?

I read in the documentation that only max 50 PSI sensor is supported as a sensor type for fuel pressure in the latest firmware.

 

[Dynon]

Unfortunately not. 50 PSI is the highest supported pressure sensor on the EMS-D10. See https://www.dynonavionics.com/includes/guides/EMS-D10_EMS-D120_FlightDEK-D180_Sensor_Types_Table_thru_v5.6.pdf