Kavlico fuel pressure sender

davejohnson

New Member
Joined
Apr 2, 2010
Messages
10
I am installing a ULPower 350Is (injected) and have the Kavilco fuel and oil pressure senders. When I run the electric pump (either of them) I get a pressure reading of 11psi, it should be around 35psi. My first thought was that I had swapped the oil(150psi) sender with the fuel(50psi), but have checked them and they are the right way around. Any suggestions as to what is wrong?
 

dynonsupport

Dynon Technical Support
Staff member
Joined
Mar 23, 2005
Messages
13,227
Dave:

Which of our EMS systems do you have?

Did you configure the EMS to specify that you have the correct sensor type?

I am installing a ULPower 350Is (injected) and have the Kavilco fuel and oil pressure senders. When I run the electric pump (either of them) I get a pressure reading of 11psi, it should be around 35psi. My first thought was that I had swapped the oil(150psi) sender with the fuel(50psi), but have checked them and they are the right way around. Any suggestions as to what is wrong?
 

BlueCH750

Low and Slow
Joined
Apr 11, 2016
Messages
85
Dave,

Did you ever figure out your issue? I'm starting my sensor installs and wiring now on my UL350iS...Thanks!
 
Top