Network configuration error

[Louiscfi]

I have a d100 and d120.  I normally power on the d120 first, then the d100.  About 10 secs after I power on the d100 I get a "network configuration error" message.  Once I clear the message I never get it again during that power cycle.  Is this just a function of the d100 powering on and not networking right away w/ the d120 or is there something actually wrong?  Thanks in advance for any help.

 

[dynonsupport]

This is because the D100 doesn't see the D120 right away at boot. We generally expect all the Dynon equipment to be turned on at the same time. We can be on during engine start, so most people just hook everything to the master and throw one switch to get it all running.

If you want to stay with your method, there's no issue except the network config error that you will get.

 

[Louiscfi]

thanks for yet another quick reply and good info