NO ADS-B OUT: GPS LOST

[loopfuzz]

After installing a 2020 GPS on a sky view classic we are getting this message "NO ADS-B OUT: GPS LOST". GPS is still working on the map.
Also I have update the settings in the dynon config to tell it we are using the 2020 GPS now.

Any ideas? Thanks in advance.

 

[BlueCH750]

How do you know the GPS is still working on the map? Are you out of the hangar with good satellite acquisition?

 

[XPRSAV8R]

What transponder do you have? Also, are you testing on the ground or in the air?

 

[GregC]

If you have no GPS signal, you will get that message, and have no ADS-B out. (Been there, done that....) I suggest you carefully follow the troubleshooting and testing instructions in the SkyView System Installation Guide - Revision AE, on pages 8-12 through 8-15. It's not that hard, really.

 

[stevelesak]

My ADS-B and GPS were working fine but not now. I have GPS as the lat/long shows correctly and I can navigate to a point but still get message. Antenna has been replaced once when had same problem.

 

[DBRV10]

Did you set the Serial Port 5 to be the 2020 unit instead of the 250?

 

[djones]

You need to change the GPS data source in the transponder setup menu to the GPS 2020. Go to SETUP > TRANSPONDER SETUP > GPS DATA