Programming the system

[carl_nank]

I have the Dynon D100, D10 and HS34. I see there are 3 PC connections, one for each instrument. I am near the programming time and have read the instructions.

If I read the instructions properly, I am to hook up the PC to the EFIS.

My questions are, am I correct to hook the PC to the EFIS connection and what are the other two PC conections for?

I appreciate your help.

 

[Brantel]

Well you don't really program the system thru those ports but you can update the firmware thru them.

All of the Dynon products on the DASB bus must be running the same firmware.

Each device you have must be updated individually so you have three ports to do that with.....

Hope this helps!

 

[dynonsupport]

Each device's firmware is updated, one at a time, via its own 9 pin D-sub connector. So yes, you start by connecting the EFIS-D100 to the PC, then do an update. Then repeat with the EMS and HS34.