Did anyone else provide protection for the roll servo wires to prevent them from chafing on the servo support bracket?
Thought about placing the wires in heat shrink, but was worried that the round wire bundle would then rub as the wires come out flat and there isn't much room.
So, instead added some silicone on the support bracket to prevent the wires from rubbing on the metal.
Thought about placing the wires in heat shrink, but was worried that the round wire bundle would then rub as the wires come out flat and there isn't much room.
So, instead added some silicone on the support bracket to prevent the wires from rubbing on the metal.