I’m new to these forums so be gentle!
Yesterday I was going to go flying (Vans RV12) the aircraft is fitted with Skyview touch (SV-D700/SV-D1000) version 15.3.4.4867
From startup I kept get the verbal warning ‘engine speed’
The RPM remained stable but the arrow pointer was jumping all over the place. One minute it would be 2200 revs then 3000 the 700. Every time it jumped to either a high position (red) or low position (red) the verbal warning popped up.
There was no change in the actual engine revs throughout this.
When the engine warmed the dial turned green but the arrow pointer still jumped around and gave warning when it jumped to the higher or lower red sections.
I rebooted a number of times but no change.
I tried again today and it was the same, however after a few minutes the arrow pointer just jumped about a bit and has since then remained static in the lower red area.
Any ideas or suggestions would be welcomed.
Thanks
Yesterday I was going to go flying (Vans RV12) the aircraft is fitted with Skyview touch (SV-D700/SV-D1000) version 15.3.4.4867
From startup I kept get the verbal warning ‘engine speed’
The RPM remained stable but the arrow pointer was jumping all over the place. One minute it would be 2200 revs then 3000 the 700. Every time it jumped to either a high position (red) or low position (red) the verbal warning popped up.
There was no change in the actual engine revs throughout this.
When the engine warmed the dial turned green but the arrow pointer still jumped around and gave warning when it jumped to the higher or lower red sections.
I rebooted a number of times but no change.
I tried again today and it was the same, however after a few minutes the arrow pointer just jumped about a bit and has since then remained static in the lower red area.
Any ideas or suggestions would be welcomed.
Thanks