Recent content by Belly3870

Thanks Raymo! I did, it looks like my antenna went bad. getting a replacement now.

no Im not getting anything from Rx or Tx. Only group errors. the connections all look good.

I have the Dynon Transponder and the Dynon 2020 GPS

Im having the same issue. It was working fine for a while and then just stopped. I get the "NO ADSB No GPS Position" message as well. do you think the GPS itself went bad?

Great, thanks!

I'm installing a wideband oxygen sensor and am out of panel space. The units controller has an anolog output for display to external units, or connection to an EMS. Is there a way to connect this output to the Skyview to display the information on the Skyview EMS display...

When my flaps are down the aileron and elvator trim indications at normal. When I put the flaps up the aileron indication goes full right and the elevator indication goes full nose up. When I start putting the flaps back down the indications go back to normal. I'm running a VP-X Sport and a...

I get an Audio Subsystem Fail warning message on the display. I don't use any of the audio functions or wires. Thoughts?

Has anyone installed a skyview with a Rotec R-3600?  If so how did you wire the tach readings?  Did you just hook up the tach output wire on the electronic ignition modul to the tach input on the EMS? Also does anyone have the physical dimentions of the amp shunt? Thanks, Brian...

Good to hear! Do you have any idea on if there will be an internal two place intercom? I'm trying to plan my wiring right now. Thanks!

I know is might be a little pre mature, but I am i am in the process of installing the sky view wiring in my aircraft and am wondering if your panel mount comm will have a serial data connection to the sky view.

In talking with the dynon reps at sun n fun they said it will be a seperate radio wi a remote head. My only concern was that they were going to only make it a vertical mount. This configuration won't fit my panel.  If they could make it horizontal I could have an all dynon panel in my rv-8.

Any word on a release time frame for your panel mount comm, and if it will have the option of vertical or horizontal mount? Thanks!

Thanks for the replies! What is the advantage of having a second antenna?

With a dual screen sv setup do I need to instal two sv-gps-250 receiver antennas, or is one sufficient?