Previous Forums and Content Archive - Read OnlyWe've reorganized the categories for 2019 and beyond, but all of the great content, information, answers, and discussions from the old forums are still intact - including attachments! Note that these forums are read-only, but are still fully searchable.
1. HDX1100 Audio Out (Pins 13, 31, and 30). Where do they connect to the Com 2 inputs to the GMA245? 2. SV-COM-T25 Phones and Mic connections (Pins 1, 2, 23, 15, and 9). Where do they connect to the GMA245? 3. Alert audio: continuing audio alert for a disconnected/malfunctioning EGT probe for instance. Might I route any of the alerts through the GMA245 so I can turn the audio off/down?
I reviewed Tommy's post from 2017 and I have a similar problem/request.
I am trying to connect a Dynon SV-COM-T25 radio (25-pin connector) to the Garmin GMA245 audio panel.
Also a Dynon SV-COM-PANEL (15-pin connector) to the SV-COM-T25.
And finally, the Dynon SV-HDX1100 to the GMA245 audio panel.
The SV-COM-T25 radio will be wired in as my "Com 2" radio; (IFD440 will be "Com 1").
Thanks for any help!
Hi Russell, I was going through the classified adds and I noticed your comments about the scammers. I also have been hit with several attempts to rip me off for a D180, HS34 and AP74. I was wondering if you had any luck in locating a D180 or if you possibly had an extra?
Hey there, is your flight deck D180 still available? I’m interested.
I responded to your ad with some question, someone named alexss responded with “what’s your address, I’ll ship it tomorrow .” That sounds a little fishy to me.
Hi Mark P.
I have the same problem with both my Dynon Skyviews…both have stoped displaying the ammeter which has a “X” over it.
Fuses and shunt are good and I checked for loose connections…
Did you ever figure this out on your plane?