Bryant Paulsen's latest activity

Caution with the copper bus bars, make sure they are covered with something during install, or inaccessible from your seat. I ruined a...

A visit today at Six Pack Aero revealed that the wiring has been completed for the push/pull circuit breakers and control switches...

A visit today at the Six Pack Aero hangar revealed more great work in progress!

Thank you for the feedback about the various components, for that is appreciated. 👍

Full disclosure: I lack the training, skill sets, and experience to answer your avionics/electrical questions. It's probably best that...

Great progress to report on interfacing the Dynon SkyView HDX, the Avidyne, IFD440, the PS Engineering PMA8000G, and one Dynon control...

Scope this cool project out... an airplane quilt! The backside has minkie on it, so it's incredibly soft and warm. This quilt pattern...

Six Pack Aero is making progress with wiring up some of the components for the new panel. It’s a work in progress…

The fuel transducer was installed today, as well as the manifold pressure (vacuum) line. AN hardware was applied to the pitch servo, so...

Thank you for the heads up about this issue, for that is appreciated. I'll chat with the shop about the torque value that is applied to...

Make sure the roll servo bridle cable clamps are torqued correctly - the torque specs have been changed from the original documentation...

I just had to pay a visit to Six Pack Aero this afternoon to visit N22230... The 172 Roll Servo Guard Service Bulletin has been...

More progress... The magnetometer and Dynon GPS antenna have been mounted. Wire harnessing in the wings are installed and secured, as...

Six Pack Aero is in the process of installing the roll servo in the left wing and complying with the Roll Servo Cable Guard Service...

Right-O, Chris. Will do!