Recent content by Daniel B

Technically, I agree that it works, but what do you think of Dynon's statement on their website: "At this time, Dynon does not make any claims about the SV-GPS-2020's applicability or usability outside of the US to satisfy ADS-B Out or other requirements." In Switzerland, a position source...

I fly in Europe and would like to upgrade to ADS-B Out. I see two options: Dynon SV-XPNDR-263 transponder with ADS-B Out and the Trig TN72 position source (EASA ETSO-C199 certified). Integrate the Trig TT23G into the Skyview, similar to the SV-XPNDR-263 transponder. This brings me to my...

I am currently redesigning my panel. Reading the Skyview installation manual I ended up with the following question: I will use the SV-COM-X83 as the displayed com at the top bar (tune com). The SL30 will be connected to the Skyview using the serial connection for navigation purposes. As a...

Update the title in the document. Regards Daniel

Hi, I'm currently drawing the new panel layout. The SV-HARNESS-D37 harness includes an USB connection. But I was not able to find out what is the type of the interface (male / female, A?). Can you provide a photo of the harness with the usb interface? Thanks Daniel

After the advice I got at the exhibition AERO in Germany, I connected the servo with new wires next to the EFIS. My fault was, that I did mix up GND and PWR.... before, when I tested the assambly, I checked only the voltage, but did not check the polarity.. :-/ And now everthing works well...

So I had the RMA#7032. I will call you on Monday. Thanks Daniel

Hey Dynon support, any ideas? Regards Daniel

I had the D10A by the end of last year shipped back and you repaired the unit. Yesterday I found the time and the temperature to connect the servo again. I checked all the connections before I tried to configure the DSAB bus. Unfortunately the unit could not find another device at the...

I will check the wiring at the back-side of the unit during the weekend. Daniel

I tried to update the system, but did not get a result. Errors see attachment. Last Sunday I did a backup of the unit with the same cable and notebook as today and it worked as expected. Daniel

I just installed and wired my roll servo to the D10A (5.1.1). Then I tried to configure the DSAB menu and received the message "DSAB could not be configured" "error code 3" "Contact Dynon Support". What did I wrong? Daniel Lancair 360 HB-YMF

Today I did 4 flights and everything was ok. Proper booting, keep alive still connected, no strange behavior. --perfect, but strange-- Daniel

Yes, I have connected the keep alive power wire. I will try it without keep alive connected to power next Saturday. Daniel

I upgraded in January to 5.0. All the flights were normal, no troubles on the D-10A. After doing some calibration last week and changes at the checklist I upgraded to 5.2 and did a backup. Yesterday I did my first flight after the changes and had the same situation as Dave described. As I...