Recent content by freerangequark

I took the recommended font and changed the "I" as well as its width. The original font also had a dot in the middle of the zero and I removed that too. I can't attach a *.ttf here though. PM me with your email address if you would like me to send it to you. Use at your own risk 😁

I too had contacted Dynon and received the same answer. It however appears to be incorrect at worst, or modified at best. Looking at the Bitstream Vera Sans Mono Font Family, you'll see that the capital "I" has horizontal lines at the top and bottom. On the Dynon Skyview Components, the "I"...

I just mentioned I learned on IFR steam gauges and hand flying. I do like glass though! :) Absolutely agree that accident rates have gone down over the years, and there's a good case to be made that better automation and system design has helped a lot with that. while automation's probably a...

I just rewatched "Children of the Magenta Line". Sadly, stick and rudder skills are becoming a scarcity among so many pilots training to be button pushers. :( I always recommend getting time in tailwheel, gliders, aerobatics, and for fun, some formation flying. Great skill builders!

I haven't used my instrument rating as PIC in over 20 years, when I was flying on steam gauges. I am interested in getting back to instrument flying. I have sim and aircraft time scheduled to start to bring me back up to speed on IFR Flying. I also have access to a Pipistrel Virus SW with a...

@Niall Leslie Unfortunately the capstan model won't work for my application. Just out of curiosity, why a capstan servo? My wife's Virus has AP and both are arm drive just fwd of the parachute.

It's also worth mentioning that while the units are adjacent as viewed, this is only showing the size of the bezel which sits aft the panel plane. The actual panel cutout is smaller. This leaves connected panel material between the units. Thanks!

Not yet but it does seem it would be easier to get to with the left hand then having to switch hands off the stick to get to them with my right hand.

This keeps my right hand on the stick. I really like that idea. I'm not thrilled with the aesthetic, but I'll keep working on it.

While I agree that symmetry often creates visual harmony and is inherently pleasing, but design rooted in function tends to have a deeper, enduring beauty. Balanced asymmetry, where purposeful imbalances achieve visual equilibrium, can be equally compelling. I think i it is worth looking at In...

One more item to consider... The PS Engineering PM1200 is the remote head version. I had a close look at it today... it is a small toggle switch and two potentiometers/knobs. Doesn't even have an LED power indicator. This means I can make the faceplate for the intercom significantly smaller...

Timber Tiger ST-L clipped wing in civilian colors. https://glennsgordon.com/project/timber-tiger-aircraft/

Three variants. 1 - Vertical 2 - Horizontal #1 3 - Horizontal #2 NOTES: 1. The lower right panel is a drawer. 2. I can easily remove the intercom from the panel altogether to reduce clutter. That will create an aesthetic asymmetry. Yes, form follows function, but the aesthetic is also...

It was my understanding that the original Dynon comm was junk and that the newer Dynon comm radio is Trig underneath. Can anyone confirm this? As for the intercom... What you see is a remote head PS engineering 1200 high noise environment intercom which includes push to intercom function. I...