Recent content by GeorgesGolf

I had also a failure on my right screen and the transponder was no longer displayed on the other screen. But when I shut off power on the right screen the transponder was again displayed and working. Georges

On the next flight all was normal. I will take pictures if this bug appears again.

Today I load the latest update and made a flight and the defaults were no longer present.

On my last flight the last digit of speed and the first of altitude were sometimes not displayed. For example for speed you see 13 instead 135 but 134 and 136 were correct. For altitude 4999 was displayed but for 5000 and higher it was the last free digits. At about 10000 complete altitude was...

Hi, After 25h on the aircraft I got the message on one of my 2 screens "boot error....contact Dynon if error persists". I restart several times and also with the 1,2,5 buttons but I got always the same message. Is there a way to fix this? Thank you

Does the autopilot can work with only the ADHARS 201 because My ADAHRS 200 is removed from the the plane due to a malfunction ?

At the adahrs end. Wiring goes from the adahrs to a splitter and from the splitter to the SV-NET-HUB.

I changed the wires between the 2 units and failure stay on the adhars 200.

Zero airspeed calibration is done. Speed indicate 0 in the hangar when the 2 adhars work properly. I suspected a bad electric connection but after changing the plugs the malfunction is always on the adhars 200.

I just make my first engine start but not yet flown. I have 2 skyview touch with 2 adhars (purchased in July 2016) and on one of them sometime the speed bar flicker with a bad indication of speed witch should be 0 in the hangar. When it happen pitch is slightly wrong also and sometime I get a...

Hello, I just install 2 SV 1000T screens and begin to play with and I notice the fans don't start at 60° C on the CPU and 50°C internal temperature . They had start first time when acquirring satellites at lower temperatures. If I power off only one screen they start on this screen for a while...

The skyview ARINC 429 installation indicate pin3 (serial RX) should be connected to GTN pin 8 (RS 232 out 1). Does the RS 232 Ground (pin 46 on GTN) should also be connected to ARINC 429 pin 20 ground? Same question for the GPS source from the GTN to the transponder (one RS 232 wire or 2 wires...

I have a garmin gtn as first radio with a ps engineering audio panel. My 2 radio is a sv-com 83. Does the push to talk (PTT) in Pin 15 on the sv-com T8 must be connected or I leave it free?