Recent content by Graham

Hi all - thank you for all your responses. I blew compressed air down the tube from the ADAHRS end (rather than into the module which would have damaged it!). I also checked the alignment of the module which was slightly out due to the holding screws being slightly loose so these were tightened...

The stall warning derives from the Pitot. It’s one system with a tube running to the ADAHRS. I’ve applied compressed air down the tube at the ADAHRS end recalibrated on the ground before recalibrating in the air-still the same issue. I’ve had the aircraft (kit build) from new and it’s always...

I have done several full stalls and the wing drop is very severe. The problem persisted but after the full stalls I was told by someone experienced with Bristells not to perform them as they have caused fatalities. I’ve 2000 hours on various aircraft and I have to say I can understand what this...

Around 46 knts- we cannot do a full stall in the Bristell due to potential severe wing drop so that's as far as I am comfortable with. However, the issue isn't that as such. During ground roll - no stall warning, immediately after take off stall warning even when the nose is lowered to get the...

Good morning-you’ve reacted to my post about the stall warning. Are you having similar issues - any suggestions? Thanks Graham

Hello all-can anyone assist. I fly a Bristell NG5 with Dynon HDX. The stall warning inhibit is set to 35knts. On take off the stall warning sounds despite not being close to the stall - it continues for around 10 ear blistering minutes even when in level flight doing 85 knots until the green...

Thank you ZK-SVH. I have sorted the radio and also now understand the Dynon cannot be connected to the transponder. Happy flying and thanks for the response

Hi all - how easy is it to connect the Dynon HDX to a Trigg TY91 radio and a TT21 Transponder so that I can input radio and squawk frequencies using the dynon touch screen rather than fiddle with the knobs? Can it be done? I know the radio frequency can be displayed but can you push the...

Did you ever get a response from Dynon about this issue as mine is doing exactly the same. Keeps flicking to AP, tried re-installing firmware, turning on and off….nothing seems to work…thanks Graham

Thanks for your replies - I have seen all the videos but it would be useful to actually do it "live" without being in the air to fully focus on all its functionality - videos have certainly been helpful but there is nothing like getting actual experience through use albeit on the ground. Trevor...

Hi all - I have the above install in a Bristell. Does anyone know whether Dynon are creating a simulation software package to load on to the Dynon or even a standalone simulation package for all Dynon users to get better experience of all its functions whilst on the ground!? I have seen a thread...