Recent content by Ludger

  1. L

    Connecting D-100 and GPS 251 -> missing wind data

    Thank You for the hint - i didn't find it on Your website before. Sorry.
  2. L

    Connecting D-100 and GPS 251 -> missing wind data

    Today I tried the connection as described in the script from September 2016 an there in Table 3-2 "Pin Assignment for GPS-251" (see Reply '12), named "Dynon EFIS-D10A/D100   STC SA04075CH - Installation Manual   Document Number: TJJ-MAN-02   Rev. B   Date: 19 September, 2016   EAA STC, LLC ...
  3. L

    Connecting D-100 and GPS 251 -> missing wind data

    Meanwhile I found the script from September 2016 an there the Table 3-2 Pin Assignment for GPS-251 connector: GPS wire color gray/orange (GPS-251 Rx)      ->      EFIS D 100  DB25 pin 10 GPS wire color gray/violet (GPS-251 Tx)      ->      EFIS D 100  DB25 pin 22 GPS wire color black (GPS-251...
  4. L

    Connecting D-100 and GPS 251 -> missing wind data

    Today I checked the wires again. Switching the data wires seems not to be the solution. Yet I was only on the ground, not in the air. Is it right that there's no winds aloft displayed when on the ground? HSI screen: no change. Also checked the setup for the HSI and there the GPS was not...
  5. L

    Connecting D-100 and GPS 251 -> missing wind data

    Now the CT is on tour for one week, so I can't check if TX and RX wires are flipped. Where did I get the in my first post discribed wiring instruction from? It was "Table 2-1 Pin Assignment for Female 25-Pin Harness" page 2-4 from document "Dynon EFIS-D10A/D100  STC SA04075CH - Installation...
  6. L

    Connecting D-100 and GPS 251 -> missing wind data

    Today checked all 4 connections (GPS-251 <-> DB25 at EFIS): The wires are ok and certainly connected as discribed above.
  7. L

    Connecting D-100 and GPS 251 -> missing wind data

    Today I checked: 1. Between GPS wire color black (GPS-251 Ground)  <->  EFIS D 100  DB25 pin 9 and GPS wire color orange (GPS-251 Power) <->  EFIS D 100  DB25 pin 12 I measured 11.86 Volt (while at the battery poles are 13.6 Volt) 2. Further: there is a sticker at the wires of the GPS that...
  8. L

    Connecting D-100 and GPS 251 -> missing wind data

    Today we checked for the answers: First, is the OAT still displaying? -> YES Next, is the baud rate for the serial port on the Dynon set to 9600 (or auto)? -> YES (I tested both) When you change the D100 to display the HSI page, what do you see above the HSI in terms of text? -> In Yellow: BUG...
  9. L

    Connecting D-100 and GPS 251 -> missing wind data

    I got the following problem with my Dynon: In my CTLS (2010) from Flight Design I had installed: Dynon EFIS D 100 & Dynon EMS D 120 & GPS Garmin 695. The GPS Garmin 695 was replaced by an iPad mini and for the Dynon we built in the Dynon GPS 251. Following the instructions the 4 wires of the...
Top