Marc_J._Zeitlin's latest activity

Keep in mind that the breaker is there to protect the wiring, not the device. If you have multiple power wires originating from a single...

This one seems to be going nowhere, locking it down. I invite the OP to contact support directly at support@dynon.com

This is all available in the installation manual, plus you should open up the cowling and *look at the wires*. This would probably have...

No, it is not OK to just "use the brown wire". You have to use the correct brown wire for the sensor type. CHT uses J-type...

the brown is just the jacket. K type (EGT) are red/yellow, J type (CHT) are red/white.

I'll start. "R"

Do we need to say it?

22AWG wire will carry max 7 amps. So a very short duration in excess of 3 amps will not harm the wire

The only concern I'd have with putting them both on the same CB is that if the ADS-B faulted and tripped the breaker, you'd lose your...

Nope.

Traffic shows up on the 2D map, and it will show up as an icon on the main PFD screen as well (if you have it turned on for each).

Whether you have an AP head or not, did you not install a remote "Disconnect" switch, to the servos? That's the thing that you're...

Didja read post #4?

One exception - per 91.215(c), if you're in uncontrolled airspace (Class G) that is not part of the airspace defined in 91.215(b), you...

See below for my current panel. I'm running the 440 dual 10" HDX. I see no value in the 540 since all it does is give you more glass -...