mwtucker's latest activity

Thanks for posting the solution. I had probably accidentally used the number label rather then L and R. In reading the Installation...

UPDATE: I spoke with Dynon Tech Support today. Simple solution: In the Sensor Mapping Screen, I needed to use "CHT 1" and "CHT 2". I...

Excellent. On my widget drop-down, I don't have "EGT CHT TEMPS" as an option... It's not on the list. This is good info... Let me...

Thanks.

I couldn't get it today. Here is the location of the editor: Installation Manual SETUP > EMS SETUP > SCREEN LAYOUT EDITOR. I'll try...

OK...thanks for that. Mike

Thanks. I wonder if it is because I have 4 EGT probes and only 2 CHT sensors (the 2 that Rotax supplies)? Perhaps the number of EGTs...

I have been trying to get a combined CHT/EGT graph displayed across the bottom of the display. I can't figure out how to do this. Does...

Rotax 912ULS. No mixture control for leaning on the Rotax 912ULS. I thought it might be related to the temperatures for the ranges...

Attached is a different photo. Inside the graph it shows 75 and 76 degrees F for the Left and Right CHTs respectively. These are...

In the configuration menu under Local Display Setup there is a GPS fix status. Shows fix quality information for the GPS source that is...

Hi Glenn, I should say that I have installed all the Dynon system components and I am playing with the setup and configuration. 1. On...

Thanks very much, Glenn. I can see the RX and Good Sentences counters incrementing. That convinces me that the SV-GPS-2020 is...

I have 4 EGT probes, one for each cylinder. I have labeled these in the setup as EGT1, EGT2, EGT3, and EGT4. I see the 4 EGT readings...

I'm in the hangar (no satellites are visible). How can I tell if my SV-GPS-2020 is communicating on the network? The SV-GPS-2020 does...