Recent content by mwtucker

UPDATE: I spoke with Dynon Tech Support today. Simple solution: In the Sensor Mapping Screen, I needed to use "CHT 1" and "CHT 2". I had used "CHT L" and "CHT R". The combined display will only work with the digits, not L and R. I made this change and the combined display is available...

Excellent. On my widget drop-down, I don't have "EGT CHT TEMPS" as an option... It's not on the list. This is good info... Let me play a bit more. Thanks, jnmeade!

Thanks.

OK...thanks for that. Mike

Thanks. I wonder if it is because I have 4 EGT probes and only 2 CHT sensors (the 2 that Rotax supplies)? Perhaps the number of EGTs must equal the number of CHTs for the Combined graph widget to work? Do you have 2 EGTs and 2 CHTs (coolant)?

I have been trying to get a combined CHT/EGT graph displayed across the bottom of the display. I can't figure out how to do this. Does anyone have a Rotax 912ULS with the combined display? I am beginning to think this is not a supported widget for the Rotax. I have 4 EGT probes on the...

Rotax 912ULS. No mixture control for leaning on the Rotax 912ULS. I thought it might be related to the temperatures for the ranges (e.g. green, yellow, red...) Those values have not been programmed yet. The engine has not been started yet. Maybe it is something that is associated with the...

Attached is a different photo. Inside the graph it shows 75 and 76 degrees F for the Left and Right CHTs respectively. These are correct readings. At the top of the graph, "99" and "26" are displayed... What are these numbers? When I play with the screen editor, these values show up as CHT...

Hi Glenn, I should say that I have installed all the Dynon system components and I am playing with the setup and configuration. 1. On some screens, I can see "CHT L" and "CHT R" with the correct (room) temperatures displayed. On the screen below, I see 100 and 27 displayed with no labels...

Thanks very much, Glenn. I can see the RX and Good Sentences counters incrementing. That convinces me that the SV-GPS-2020 is "online". Mike

I have 4 EGT probes, one for each cylinder. I have labeled these in the setup as EGT1, EGT2, EGT3, and EGT4. I see the 4 EGT readings on the graph, but the cylinder numbers are not displayed--only 4 numbers at the bottom of the bar graph. All 4 read 75 degrees F (correct). Should the "1"...

I'm in the hangar (no satellites are visible). How can I tell if my SV-GPS-2020 is communicating on the network? The SV-GPS-2020 does not appear in the list of detected devices (but there is a disclaimer about the SV-GPS-245). I was looking for a screen that might say something like...

Thank you!

I have a different ammeter shunt than the one supplied by Dynon, so I need to edit my Sensor Config File to change the c_X1 constant. I have the downloaded "duc" software file on my desktop computer. Does the software update need to be installed on the HDX system and then the Sensor Config...

Hi Mike, not sure about ForeFlight yet...I'm still building my aircraft. You may want to post your question in a different section of the forum...more people will see it.