Recent content by ned

Sign up at https://www.flysto.net/ , After creating an account, you can upload the dynon user file to the app for detailed viewing of recorded data. Very useful for viewing all flight data.

Are you in expert mode?

I am having the same issue with a vertical unit 5 years. Also, I absolutely hate the button holding time delay for release of an engaged selection.

Really? The guy is flying a Zenith 750. The necessary bases were covered. Thank you

You do not need ADSB to fly in the US if you stay out of class C and Class B/shelf. Yes, I have it and wish all did.

Same thing they told me back in August of '23. https://forum.flydynon.com/threads/adsb-ok-and-wx-radar-nexrad.14952/#post-87790 Still having the same issue. They said "send the unit in for analysis" however, all indications are that the unit is fine.

My Skyview system was purchased in 2014 with the back up battery and put in service in 2016. Today I did the yearly test for the battery and again the test was successful. Final voltage 10.45. Not a bad service life going on 11 years.

I am also having a intermittent issue with ADSB in. I have the SV-ADSB-470 installed for 6 years with no issues until recently. ADSB status will always show receiving when the ADSB NO RADAR issue arises. Targets disappear during wig out. happens at various altitudes. The issue has even occurred...

A A/P works as you described. Thanks for the info.

Thanks. Will check it out Tuesday.

Recently installed 16.4.4. Expert a/p mode. I routinely decouple trk/hdg with the ap panel basically leaving a/p in altitude hold while I meander around the sky viewing the scenery or allowing a passenger to steer the aircraft. After 16.4.4 the trk/hdg buttons will now not disengage either mode...

Updated firmware and made first flight with AGL indication on screen. Worked flawlessly and I am now a happy camper. Thank you Dynon.

push <direct to > rnwy > set green pointer to desired runway then push <direct to> again.

Affirm-the external button works in both modes. Once you use the expert mode you will unlikely return to the simplified. Simplified does not allow independent use of altitude hold or wings level.

I agree. One would need to label the integrated level button INOP while in simplified mode? Seems rather non intuitive to me. This is one thing that should be change. I do have the AP panel and a external level button but only because I built my plane before Dynon released the AP and switch panels.