Recent content by pazmanyflyer

After after DEEP dive into the internet rabbit hole last night I found an example that is very close to what I wanted to do. The example was the 650 + G5. Short story: I'll use separate 650 arinc outputs from the 650 to the the Skyview and AV-HSI. This allows me to set up each individually per...

Anyone have a wiring diagram for the GTN650 + AV30E (with AV-HSI) + Skyview? I'm currently planning an IFR upgrade to my Skyview equipped RV-7. I've drawn up a wiring diagram but I'd like to have a look at someone else's working example to compare them. I think I have the Skyview 429 wiring...

I've been sitting on a GTN 650 for over a year hoping Dynon to bring in a GPS/NAV unit since last OSH. I could just go with the GPS only but I too like the idea of a backup. So how long before the release of hardware into the field for installations? Maybe soon. Maybe a year or more. I guess...

Same here. Works fine.

Hi all. I have a VFR panel (10" HDX, (1) SV-COM) and I'm adding the 355 and Val Nav 2000 to move into IFR. I'm not a professional installer and I'll figure it out but I'm looking for some guidance as to how to wire the 2000 to the Skyview. I know the 355 will use the SV-ARINC-429 but not the...

Good to know. Thank you.

It's an MFJ 30A power supply. I did have it connected to the battery. I'm sure ATC will tell me if I have any further trouble when I start flying.

Hello all. Prepping for my AWC and first flight I had my VFR transponder check on Friday. I had the plane (RV-7) plugged into the power supply so there wouldn't be any power issues while testing. Once test started, the test equipment was showing transponder not locking on the squawk codes. Alt...

The EFIS has been sold.

Email me direct at pazmany.ch@gmail.com and we can chat about it. -Carlos

Dynon SV-D1000T/B (10" touch) EFIS. No connector or wiring since it has already been installed in my RV7 project. S/N 22328. Purchased from a fellow RV builder when I started building my panel 2 years ago. Previous owner sent it in for screen repair and refresh in June 2018. New screens, bezels...