Raymo's latest activity

  • Raymo
    Raymo replied to the thread Tosten Grip Wiring - CS8.
    They can both go to a common ground. If you are using the Dynon AP button panel, it provides relay functionality. If not using it, you...
  • Raymo
    Raymo reacted to DBRV10's post in the thread D10 EMS with Like Like.
    Why not buy the SV-EMS-220 module and solve the entire problem. All the harness plugs will go straight in to the SV system. Then sell...
  • Raymo
    Raymo replied to the thread Dynon Skyview in S35.
    You're going to want EGT in the engine strip so you can properly lean during climb and cruise. Once you know where the cylinders peak...
  • Raymo
    Raymo replied to the thread IAS to CAS.
    Why not use TAS, which the system already provides. In zero wind flight, TAS will match ground speed.
  • Raymo
    Raymo replied to the thread AP auto trim aileron.
    Yes, sounds correct, assuming it is unbalanced now.
  • Raymo
    Raymo replied to the thread AP auto trim aileron.
    It is simply trimming to unload the AP servo. Could be due to a cross wind or unbalanced springs.
  • Raymo
    Raymo reacted to Shawnb737's post in the thread Dynon Skyview in S35 with Like Like.
    So after owning my plane for a year and a half and doing a ton of research on the direction I wanted to go I finally pulled the trigger...
  • Raymo
    Raymo replied to the thread Servo Arm Length.
    Slight correction: The jam nut is not tight.
  • Raymo
    Raymo replied to the thread CHT and EGT.
    Assuming you have CHT probes wired into the EMS, add the widgets in the various EMS pages. The installation manual has more detailed...
  • Raymo
    Raymo replied to the thread ADSB out question.
    If you have the GPS-250 puck set as your ADS-B out source, it will not pass the test. Either use your 430W (assuming proper firmware...
  • Raymo
    Raymo replied to the thread Garmin GPS 175 with SkyView.
    Yes, the GPS-175 will work fine with the Dynon and is priced competitively. You'll also need the ARINC-429 protocol converter to feed...
  • Raymo
    Where are you located, Tom? I'd suggest finding someone in your area to help. You'll need to redo some of the trim control wiring...
  • Raymo
    Raymo replied to the thread Engine Monitor Failure?.
    Sounds like the SV is telling you the truth, that you still have a charging system problem. What voltage do you see at the battery when...
  • Raymo
    Raymo reacted to HFMan's post in the thread How to do a battery backup test? with Like Like.
    I was racking my brain trying to figure out what was "dangerous" about this- jees. I can also guarantee DBVR10 that there is no way a...
  • Raymo
    Raymo replied to the thread Dynon Classic not booting up.
    HFMan, Try swapping screens and see if the problem moves with the screen. If it does, consider contacting support for next steps.
Top