Recent content by Seagull

  1. S

    Some ADS-B targets not showing.

    Ray, I had problems connecting and dropping the Dynon WiFi connection on the IPad and discovered that the Dynon was trying to connect to my phone at times when I was using the IPad. I told the phone to “forget” the Dynon WiFi and the problem went away.
  2. S

    Some ADS-B targets not showing.

    I have my IPad linked through the WiFi to the Dynon. There are times when a target shows on the Dynon but not on the IPad. Is there a setting I am missing.
  3. S

    What is this symbol?

    Thank you all. Always something to learn. I have 1200 hours with this same plane / Dynon, never saw these, good to know, a bit embarrassed.
  4. S

    What is this symbol?

    Five years flying behind the Skyview and this is the first time I have seen this, (circled)? Anyone seen this before? When I touched it the information popped up above it
  5. S

    Audio alarm setup

    I have the audio alarm turned on for fuel pressure. The low is 2.2 psi and when the pressure crosses the 2.2 threshold the audio warning announces. If the pressure stays below 2.2 psi there is no further warning. Is this normal?
  6. S

    how to put ADS-B / transponder in standby

    I have a Skyfiew touch. The other day I was in formation with another plane and ATC asked me to put my transponder / ADS-B in standby, how is that done? Disregard just saw the other thread.
  7. S

    MAP showing RED X on power reduction

    I gave some thought to what you said and did some tests. At high altitude I pulled the throttle to idle from 25”, the “X” appeared for a few seconds then the pressure read again with engine at idle. I tried again starting at 20” and 15” each time got a “X”. Starting at 10” the “X” does not...
  8. S

    MAP showing RED X on power reduction

    Today when flying the MAP gauge went to a RED X for 5 seconds when reducing power in cruise to idle. This is the same RED X, you see with no input. Has anyone seen this or have suggestions to where to start looking for the problem? My specifics. The panel is a Dynon Skyview, the engine is a...
  9. S

    Screen Freeze

    Mine was installed in 2015, the warranty is 3 years. The problem was first noticed in 2019, still out of warranty period. Since this is the only problem, I figured I would wait until something serious happens to it, the $450 is a flat rate for whatever it needs.
  10. S

    Screen Freeze

    I checked into having Dynon repair it. At a cost of $450 My "work around" is a little annoying but spending $450, annoyed me more.
  11. S

    TFR updates

    I have the 472. The TFR was taken down over a week ago. It still shows on my Dynon. I have flown 4 hours over the past 2 days, one would think it would have updated by now. I also have a Garmin 696 with a GDL39 that is still showing the TFR. My Ipad using IFly GPS does not show it. The TFR is...
  12. S

    TFR updates

    How does the Dynon panel receive TFR updates? We had a fire TFR locally (4 mi radius), it was updated to a smaller (3 mi radius) last night. The change showed up on my EFB. This morning the TFR was removed and the EFB showed that it was removed, but the Dynon still showed the 4 mi radius, I flew...
  13. S

    Screen Freeze

    I have a Skyview touch. My screen has a horizontal area on the screen that is dead. if I touch and move past that area the screen will freeze. There is an menu item that allows you to see where your touching, it shows like a finger print when you touch the screen. I turned on that option and it...
  14. S

    oil and coolant temp reading high

    Thanks for the input but please read the first post, I am dealing with oil temperature not coolant.
  15. S

    oil and coolant temp reading high

    I use Prestone Dex-Cool (orange) for coolant. I recently changed from Prestone (green), no difference in temps, I changed because the orange is easier to see in the reservoir under the cowl.
Top