SkippyDiesel's latest activity

I can understand your frustration at this ignorant Cluts, not following through on your suggestion & for that I am sorry. Your logic...

Sorry mate - Dynon have asked for other information - I have to disconnect the ADAHRS, test pin 2 & 7, report my findings 😈

ADAHRS failed again! - same symptoms as last unit, that is; Great days flying, all systems operating as expected. Go back next day...

I recommend you contact Dynon Support.

An alternative perspective: If installed as you propose, consider it as a backup instrument only. If your screen dies in flight, there...

Turne out that yes, the wires were swapped at the terminals 🤪 Not quite sure how I managed to put white to red and red to white, but...

Check that the thermocouple/sensor is working correctly - swap EGT and see of the problem moves or stays 😈

New ADAHRS module installed & compass ground/air callibration done (127%) Dynon does not seem intersted, at this time, to get the last...

Your abbreviated sequence of ADAHRS events is a tad too short; Original (first) module worked perfectly for aproximately 130 hrs Failed...

OK...since it's unlikely that you were the unluckiest ADAHRS user in the Dynon community and got two bad units, and if you're sure the...

This is the information Dynon have asked for - hope it helps 😈

I appreciate your help Swatson99 and feel that I have been responding appropriately to your questions as I understand them; "On the...

HiSwatson99, The fail, in both the original & new replacement is, a red cross with the words ADAHRS Internal Fail. As far as I am...

The original (first ) module worked faultlessly for about 130 hrs. Second, was the loan module - for about 5 hrs or so (would have to to...

Yes. As stated single, home made/designed, mast for all three functions 😈