Stevec's latest activity

At the moment AvPlan EFB provides both obstacle and navigation databases for NZ. They also provide all the chart and mapping data. OZ...

How DARE you! :D

This is a known issue. I have two HDX screens that update perfectly but a friends screen stops every time we update it. I thought there...

At the risk of getting blasted could you just have a look in the installation manual . In the EMS section there are full instructions on...

I would suspect either the wiring or the sensor. In particular check the earth connection to the engine block is not corroded or loose...

I reinstalled the nav data base and all is good. Thanks for the help.

Contact Dynon support. It sounds like you will need to send it in to them.

Have you tried reinstalling the NAV database?

Have you checked the filters that might have been invoked for NRST?

Not sure why it was done that way but just wanted to point out what works with that sensor.

I have that sensor on my aircraft. I did not install it but it is connected to pin 31which is not one of the RPM inputs but an enhanced...

EGT as an absolute value means nothing. Each probe is going to end up in a slightly different position, different distance from the...

So you didn't take the simple step of downloading the diagnostic file and the logfiles, in the event Dynon asked for them, nor so you...

Mike you have entered all the max weights as zero. Try putting in a value that reflects the maximum limits. Front seats say 500 lbs etc.

Hi Mike You have provided very little information to go on so it’s a bit difficult to give you an answer. I have found the calculator...