Recent content by wolf243_pl

Sorry for the menthal shortcut ;) What I meant was I have to check the diffrence between real fuel burn and the calculation made by the computer based on FF. And if its too much off , then change the value in sensor calibration menu. 👍

Finaly yesterday had some time to remove the old and install the new one. As far as I can tell (without openning it) the connections on the old one are fine , the turbine wheel inside is spinning freely - but the cube is not working. Im glad that the new one is 😄! It needs propably some...

I've tried to simulate the "cube" per instructions and the fuel flow came alive ! That shows the EMS is working fine. So I conected a new "cube" that I happend to have and its showing fuel flow after blowing in it !! even the low voltage is no issue anymore ;) Only thing left to do is to...

I have a FT60 fuel flow transducer mounted in my plane but get constantly 0 reading in the Dynon HDX. Pin 14 is mapped and the calibration is set. The transducer is connected to the EMS-220 with the correct pins (13, 14, 15) but I measure only 7,95V on the red cable comming from pin 15...