Ongoing problem

[hornet2008]

I continue to solve the problem of %power and fuel flow. Are the two related in the Skyview Touch? I had the unit returned to Dynon as there was a problem with it powering up and displaying two Xs. It was supposed to be fixed, still does it every time I power up. I’m in Australia and it was well over a month turn around and $1000. I put up with it as I can’t afford to send the unit back on the off chance it’ll be returned without repair as happen last time.

 

[skysailor]

Dynon Tech Support will answer by email if you contact them but I do not think fuel flow is part of the calculation. I believe it uses density altitude, RPM, and Manifold pressure. A likely culprit is not having a temperature reading which would cause density altitude problems. Do you have a steady density altitude reading (just below VSI tape)?

 

[RV8JD]

From the SkyView System Installation Guide:

 

[airguy]

What specifically is showing up with red X's? Can you post a picture of it?