Search results

  1. 6

    High RPM

    WE seem to be getting double what the RPM should be on our Skyview. Can someone give a clue as why we are seeing this. WE checked it with a external rev counter.
  2. 6

    Intercom wireing

    I am a bit confused about this. On the wiring guide power is supplied to pin 13 but dose not explain where the power comes from. Dose it just come from a switch or somewhere else that I am missing? Thanks Dannie
  3. 6

    Com radio

    I know I must have overlooked it but I can't find the installation guide for it. Can someone put me on it? Thanks Dannie
  4. 6

    Last two wires in SV-ECM

    I have everything hooked up to the engine except the red and black wires for the voltage meter. I am not sure where the best place to connect these wires or if the red wire should be fused. It may be in the instructions and I just have not found it yet. Can someone answer this for me? Thanks Dannie
  5. 6

    ADAHRS wiring

    I guess I am missing something. I can't find where in  the directions for the ADAHRS to place the wires in the D9 where it plugs into the SkyView network. Can someone please tell me where to look?
  6. 6

    Something I just do not understand

    When wiring the pitch and roll servos the diagram says the twisted wires can share wires at any point. Now my question is how dose the SV know which servo to tell to go up or down or left or right? I just can't wrap my head around this.
  7. 6

    EGT probe ?

    How close can I get to the exhaust flange without causing any trouble? I have a Vetterman exhaust and #3 is very short. I also just found out that I have 1 1/2'' tubes instead of 1 3/4'' I guess this is why it is tighter to the bottom of the engine than the pictures I have seen.
  8. 6

    Wire crimping tool

    I need to know what kind of tool to use on the engine wire harness? Thanks Dannie
  9. 6

    Pitot in RV6A

    I will be installing a heated pitot in my 6A but the wings have been compleated and I can't install it like the instruction say.My question is would it be OK to install it in the wing tip?
  10. 6

    Building a RV6A

    Hi I am building a RV6A and need some advise in where to install the ADAHRS-200. I understand behind the baggage compartment in a good place for it.If this is a good place or any other place some picture of the mount would be great. Thanks Dannie
Top