Search results

leading edge of bracket is 3.43" aft of the bell crank pivot. Still looking at possible airframe issues as the owner bought aircraft without any build info. A longer pushrod should cure it if no other causes are found. Alan

Two of us have checked the diminsions from the RV-6 install sheets, outer hole and 6" pushrod, bracket in correct location. We need a longer pushrod to put the arm at 90 degrees to the pushrod, so changing holes won't help . I had to customize the pushrod for the roll servo but it was too...

Just installed a pitch servo (SV32) on an RV6 per the drawing and the servo arm goes over center and locks , seems to need a longer push rod but 6" is called out on drawing and supplied in the kit. Solutions? Alan