Search results

  1. C

    RPM showing about double the actual number

    Thanks Rhino, while that previous post from July was helpful. I am still having the same issue.
  2. C

    RPM showing about double the actual number

    Lycoming IO-360 thats what I entered.
  3. C

    Fuel Pressure

    hey fellows, my fuel pressure shows completely INOP just a bit red X on the screen. Anything I missed during setup? checked all wires and connections already. Thank you all!
  4. C

    RPM showing about double the actual number

    My RPM read is showing about double than expected. For example, Idling my engine shows 1500~ which is obviously off. This is a new install so still figuring out configurations, setup and troubleshooting. Have me missed anything that needs to be setup? Thank you all!
  5. C

    Transponder not showing active

    Thanks a lot! I got it to be located in a serial port, but still showing offline. I need to read the documentation again unless you all can see anything else I may have missed. I am trying to determined if it’s a configuration step issue that I have not completed or we need to pull the screen...
  6. C

    Transponder not showing active

    Greetings everyone, This is a new install, going through the setup and configuration process and cannot seem to have my transponder module available to setup. My question is, am I missing something on the setup screen or do we have some wiring / ping / harness issue to troubleshot ? Please...
  7. C

    First flight - a few squaks

    I know this is probably In the documentation but I am tired of reading :) I am hoping I can get some pointers to troubleshot installation issues VS configuration issues. This is a Cessna Cardinal 180 Horse Lycoming 0-360 1) fuel flow seems too high 2.3 gl/hr on idle and 12.5 on cruising. My...
  8. C

    GPS antenna for DYnon and Garmin 175

    *Update* left the antenas where they were, about 6” center to center. Both GPS reported excellent reception, Garmin connected to 12 sats while taxing even before I reached the runway. Flights was also uneventful as far as GPS connectivity. Thanks everyone!
  9. C

    GPS antenna for DYnon and Garmin 175

    Thanks @Rhino !
  10. C

    GPS antenna for DYnon and Garmin 175

    I am installing these two on a high wing Cessna, my ideal location allowed for 6” apart. I don’t see anywhere where Dynon specifies distance between these two, perhaps I miss it, however, I just read that Garmin recommends minimum 9” separation. I already have holes drilled and antenna mounted...
  11. C

    Audio cable from Dynon to audio panel

    the PS panel I have is Stereo, PMA8000G Flightmate which is Stereo capable. So instead of twisting, the third wire would go to which Pin? Ground Pin 30 from Dynon to pin 24 on PS Pin 13 Left audio from Dynon to pin 7 or 22 on PS (unswitched) Pin 31 Right audio from Dynon to pin ??? On PS...
  12. C

    Audio cable from Dynon to audio panel

    Can someone tell me where does the audio wires coming out of Dynon harness connects in my audio panel? I am using a PS Engineering audio panel. all I could see on the Dynon documentation is the guidance of “these audit out cables go to the audio panel” however I could not find on the audio...
  13. C

    Garmin GPS 175 Installation

    Does anyone have a diagram That shows connections among Dynon to PS Engineering intercom and Garmin GPS? Thanks!
  14. C

    Garmin GPS 175 Installation

    Thanks @lancair360 !!,
  15. C

    Garmin GPS 175 Installation

    Guys, On that 175 to skyview diagram posted by @Tim Fitz, what is the config Module ? And for what equipment is that ? thank you all! -Ax
Top