Search results

https://www.aircraftspruce.com/catalog/inpages/grt-ft-lc-01.php?clickkey=2837303 This is the one I used. When you go to the sensor menu it is #3 the Kavlico is #1 https://www.aircraftspruce.com/catalog/inpages/grt-hps-01.php?clickkey=6841 This is the oil pressure sensor if you have any trouble...

I just started a thread yesterday on this very subject. My gauge would bounce around from 225-255 and was very erratic. When I would turn the field switch off it would show a fairly steady 228-235. I checked all the connections and even bought another sensor. I replaced the Kavlico sensor with a...

We have installed several Dynon systems over the last 16 years. Both the 100 series and Sky view. In the last two years we have had trouble with Kavlico sensors. Have had three oil pressure sensors that did not work. Replaced one with another Kavlico and two others with GRT sensors and they all...

I'm installing a D-180 in a Nanchang CJ6. Wondered if anyone had done one and if I can use the sensors that are on the airplane.

Tried them in my friend's airplane and no joy. So I'll call Monday and get them in to you. Thanks Don

I was running up my airplane after cleaning plugs and I tuned off the master switch while the engine was running and the alt field was still on. The D100 and D120 screens went dark. They will not turn back on with the master but the D100 will run on internal battery power. I checked and do have...

Found the problem. I was always looking at the ground wire for the problem but it was the power wire. Was loose in the molex connector at the cannon plug. I wired the power directly to the circuit breaker and ground to the ground buss it works perfectly now. Don

How timely. My flowscan unit worked perfectly for about 100hrs. Then it would get erratic and shut down. I have gone through all of the wiring and it would work for awile then shut down again. I just put a Red Cube transducer in and it worked about 5 min then went erratic and shut down. All I...

At about 2hrs flying time after downloading 5.0 the airspeed bar turned gray no yellow, green or red V speed indication. Airspeed indicator is fine as is everything else. Don

We downloaded 5.0 on two airplanes from the same computer. Would that cause it? This was actually a good thing as when I calibrated it the first time it was in a three point attitude. I have now done it in flying attitude. One other thing, this is in my RV7 with the Van's float senders and they...

I downloaded 5.0 this morning and it retained everything except the fuel quantity. Do I have to load my back up to get that info back? Don