Search results

Hi Getting a red x on the fuel pressure display until the engine is running then working ok Any suggestions pls Mark

Hi I have been chasing a fault on my Dynon sky view EMS 220 when on the standby battery the Dynon voltmeter is showing that there is 3v on the bus bar - which goes away when the 2 shunt wires used for amp display are removed Any suggestions Can someone with the backup battery running a...

These servos aren’t like the model aircraft version (but larger) they have no centre on the servo arm throws ! So until you calibrate them in the set up they will not move.

Install the servo with the limit stop and check your control throws don’t hit the stops. The servo won’t move even when powered up so no chance of any damage. The most important thing is max control throws hitting the stops which they must NOT. No need to temporary wire Mark

Hi Can anybody give me a brief run down of the set up procedure for using an external flight plan (SkyDemon) to run the Skyview autopilot ? I can export the plan to Skyview ok but unsure of which mode I should be using - expert or simple mode and from there onwards...? aircraft fitted with...

Hi I've installed a Red cube and getting not readings on fuel flow. fuel calibration has been done and set to 68,000 I have checked for voltage which is reading +12v yellow wire from the EMS connected to the white from the red cube - is this possible to test with a multi meter if so how...

Hi Can anyone tell me if the sv -adsb-472 will work with the sv250 gps unit

👍 thanks for the info

Hi can anyone tell me if the SV-GPS-250 has any effect on the ahahrs unit if mounted too close ? if so is there a optimum distance Mark

Hi Can I connect an additional dial manifold pressure dial indicator to the Dynon system using the same sensor wire connections or do I need a separate sensor for each? Mark