Search results

dear support, the cautionary warning i received yesterday was position source 1 fail some seconds after map screen turned into black, i need your assistance to fix it, thank you

i was trying to understand if the installed servo was a brand new or  second hand,   i found the answer by mailing directly to dynon support with backup photos, it was all about a warranty sticker on a continuously slipping servo after 10 hours of operation i did not want to publish photos...

Thank you, my last question is, there is a date on the servo, probably the production date, what is the format of this date, dd/mm/yy ?

Dear Expert, i have 10 and 7 inches skyview displays, rv32 roll servo and rv 42 pitch servo, today i installed brand new pitch servo 42 replacing the old slipping one, when the power was on, the first message appeared was pitch servo not found, then i reconfigured the system, the software...

Dear support, after upgrading my skyviews' software i get a warning message saying autopilot software doesnt match, appreciate if you can tell me how i can update its software

my evektor needs around, say 2-3 lbs for 15 degrees and 6-8 lbs for full flaps during flight, lever arm length is about 10 inches

Evektor EV97 10 and 7 inches Skyview

i have a 10 inch skyview, my question is about the ammeter, in the yellow range it shows positive ampere values while negative values in the green range, is this normal or a sign of a future problem, thank you

Hi Support, it says altitude cross check error, can it be the cause of unusual pitch servo command like not being able to maintain altitude, all parameters are set to default values and torque as 100%, i think even that setting is too high for my airplane, normally you can fly it by using two...

if i have one pitot tube, is cross check still an issue, i assume they are fed by one source and parameters must be the same, do i miss anything here at this point, thank you

I have skyview d1000 on left and d700 on the right side, i often get a message which wants me to compare the values , the values on the comparison screen seem to be equal, Then during level flight the Ap wants me to put in nose up trim, once again, then slip begins, when i disengage the ap...